Product ID:LAMINATING, FINISHING & CASTING RESIN (SUPDAT)
MSDS Date:11/01/1985
FSC:8030
NIIN:00N048010
MSDS Number: BTYKF

TITAN CORP

5629 208TH ST SW
LYNNWOOD, WA 98036
US

Emergency Phone: 206-775-2582

Info Phone: 206-775-2582

Cage: 4F637

TITAN CORP

LYNNWOOD, WA 98036 US

Telephone: 206-775-2582

Cage: 4F637

UNSATURATED POLYESTER

Fraction By Weight: 55%

OSHA PEL N/K

ACGIH TLV: N/K

STYRENE (SARA III)

CAS: 100-42-5

RTECS: WL3675000

Fraction By Weight: 45%

OSHA PEL 100 PPM

ACGIH TLV: 50 PPM; 100 STEL, S

EPA Report Quantity: 1000 LBS

DOT Report Quantity: 1000 LBS

LD50 LC50 Mixture:NONE SPECIFIED BY MANUFACTURER.
Routes of Entry: Inhalation:NO Skin:NO Ingestion:NO
Reports of Carcinogenicity:NTP:NO IARC:YES OSHA:NO
Health Hazards Acute and Chronic:IRRITATION OF EYES, NOSE, THROAT AND
RESPIRATORY TRACT WITH NARCOSIS OR DEEP ANAESTHESIA FOR EXTREME
OVEREXPOSURE.
Explanation of Carcinogenicity:STYRENE: IARC MONOGRAPHS, SUPPLEMENT,
VOL 7, PG 345, 1987:GROUP 2B. ANIMAL: LUNG CARCINOGEN.
Effects of Overexposure:SEE HEALTH HAZARDS.
Medical Cond Aggravated by Exposure:NONE SPECIFIED BY MANUFACTURER.

First Aid:INGESTION: DO NOT INDUCE VOMITING. SKIN: FLUSH WITH WATER.
EYES: FLUSH WITH WATER FOR AT LEAST 15 MINUTES. INHALATION: REMOVE
TO FRESH AIR. KEEP WARM AND AT REST. OXYGEN MAY BE ADMINISTERED. IF
BREATH ING STOPS, APPLY ARTIFICIAL RESPIRATION. MEDICAL ATTENTION
SHOULD BE OBTAINED.

Flash Point Method:PMCC
Flash Point:84.0F,28.9C
Lower Limits:1.1%
Upper Limits:6.1%
Extinguishing Media:EXCLUDE AIR. USE FOAM, STEAM, WATER FOG, DRY
CHEMICALS OR CARBON DIOXIDE.
Fire Fighting Procedures:USE NIOSH/MSHA APPROVED SCBA AND FULL
PROTECTIVE EQUIPMENT .
Unusual Fire/Explosion Hazard:VAPORS FORM EXPLO MIX W/AIR BETWEEN UPPER
& LOWER LIM. WATER CAN BE USED TO COOL CNTNRS. SEALED (CLSD) CNTNRS
CAN BUILD UP PRESS IF EXPOSED TO HEAT (FIRE).

Spill Release Procedures:REMOVE OPEN FLAMES, SPARKS, HOT SURFACES &
OXIDIZING AGENTS. CLEAN UP WITH ABSORBENT DILUENT. AVOID BREATHING
VAPORS. USE PROTECTIVE MEASURES.
Neutralizing Agent:NONE SPECIFIED BY MANUFACTURER.

Handling and Storage Precautions:STORE IN CLSD, PROPERLY LABELED CNTNR
IN COOL, VENT AREA. KEEP FROM HEAT, OPEN FLAMES & OXIDIZING AGENTS.
DO NOT TRANSFER TO UNMARKED CONTAINERS.
Other Precautions:USE WITH ADEQUATE VENTILATION. AVOID SKIN AND EYE
CONTACT. HARMFUL OR FATAL IF SWALLOWED.

Respiratory Protection:USE W/ADEQ VENT. WHERE REQD USE NIOSH/MSHA
APPRVD RESP IN COMPLIANCE W/CURRENT OSHA REGS. WHERE
CARTRIDGE/CANISTER UNIT PERMISSABLE, NIOSH/MSHA APPRVD ORG VAP
UNITS ARE PROTECTIVE FOR RESIN VAP IN EXP OS RANGE SPECIFIED BY
SUPPLIER. (SUPDAT)
Ventilation:LOC EXHST WHERE NEC TO MAINTAIN EXPOS LEVEL BELOW OSHA LIM.
MECHANICAL. SPECIAL:ONLY IF HEATED NEAR/ABOVE FLASH POINT.
Protective Gloves:RUBBER GLOVES.
Eye Protection:ANSI APPVD CHEMICAL SAFETY GOGGLES (FP N
Other Protective Equipment:IF NECESSARY RUBBER APRON, SHOES OR BOOTS.
Work Hygienic Practices:NONE SPECIFIED BY MANUFACTURER.
Supplemental Safety and Health
MFR'S TRADE NAME/PART NO:FIBERGLASS PUTTY. RESP PROT:IF OXYGEN LEVEL IS
BELOW 19.5% &/OR RESIN VAP CONC IS 2% FOR CANISTERS OR 0.1% FOR
CARTRIDGES OR ABOVE, USE NIOSH/MSHA APPRVD SELF-CONTAINED OR AIR
SUPPLIED UNITS.

Boiling Pt:B.P. Text:295F,146C
Vapor Density:HVR/AIR
Spec Gravity:1.1 (H*2O=1)
Evaporation Rate & Reference:SLOWER
Solubility in Water:SLIGHT
Appearance and Odor:VISCOUS LIQUID WITH SLIGHT ODOR.
Percent Volatiles by Volume:55

Stability Indicator/Materials to Avoid:YES
OXIDIZING AGENTS, FREE RADICAL CATALYSTS & PEROXIDES.
Stability Condition to Avoid:OPEN FLAME, HEAT.
Hazardous Decomposition Products:SMOKE, CARBON MONOXIDE, CARBON
DIOXIDE.
Conditions to Avoid Polymerization:OPEN FLAME, HEAT & OXIDIZING AGENTS,
FREE RADICAL CATALYSTS & PEROXIDES.

Waste Disposal Methods:USE EITHER APPROVED SANITARY LANDFILL OR
INCINERATION. DO NOT INCINERATE CLOSED CONTAINERS. DISPOSAL MUST BE
CARRIED OUT IN ACCORDANCE WITH LOCAL, STATE & FEDERAL REGULATIONS.

Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.